DIY Sew: Iphone Case

 

Materials:

1/4 yard of fabric

1/4 yard of interfacing

1 magnetic snap

plastic iphone case

embroidery floss

 

Step 1: Cut two pieces of interfacing: 4.25" x 2.5" and 8.5" x 5"

Cut two pieces of fabric: 8.5" x 2.5" and 8.5" x 10"

 

 

Step 2: Install snaps: use fabric chalk and draw a vertical line at 2.75" about an 1.5" in from there place a washer. Use a pen and mark both slits of the washer. Use scissors to cut slits where the marks are. Placing the interfacing under the fabric install the snap.

 

Step 3: With Good sides of fabric touching pin and sew three sides of the fabric



 

Step 4: Fold in fabric on side you did not yet sew, and sew

 

 

Step 5: Fold in fabric 2.5", pin and sew only the top and bottom

 

Step 6: Take your smaller piece of fabric and interfacing and install the opposite side of the snap. Mark slits, cut, install snap.

Step 7: Fold fabric over, pin and sew (top, bottom, and left side only)

 



 

Step 8: Turn fabric right side out, fold in remaining fabric and sew up right side only

 

Step 9: Sew the smaller piece of fabric onto the larger piece



Step 10: Cut out a hole for your phone's camera



Step 11: Use embroidery floss and sew around the edges of the camera hole



Step 12: Super glue a plastic iphone case into the inside back portion of your fabric, let dry, and pop in phone



 

Done!!